Installing a sink mixer tap can seem daunting, but with the right tools and instructions, it can be a straightforward DIY project. Here’s a step-by-step guide to help you install your new tap.

Step 1: Gather Your Tools You will need a basin wrench, adjustable wrench, plumber's tape, and a screwdriver. Ensure you have all the necessary components that come with the tap, including mounting hardware and hoses.

Step 2: Turn Off the Water Supply Before starting, turn off the water supply to the sink. This is usually done via valves located under the sink. Once turned off, open the tap to release any residual water.

Step 3: Remove the Old Tap Using the basin wrench, loosen the nuts securing the old tap and carefully remove it. Clean the area around the sink hole to ensure a proper seal for the new tap.

Step 4: Install the New Tap Insert the new tap’s hoses through the sink hole. Secure the tap in place with the mounting hardware provided, tightening the nuts with the adjustable wrench.

Step 5: Connect the Water Supply Attach the hot and cold water hoses to the corresponding valves. Use plumber’s tape on the threads to prevent leaks and tighten the connections with the adjustable wrench.

Step 6: Test the Tap Turn the water supply back on and check for any leaks. Open the tap and let the water run to ensure it is functioning correctly and there are no drips or leaks.

By following these steps, you can successfully install a sink mixer tap, enhancing both the functionality and appearance of your kitchen or bathroom.